Juniper-systems I/O module Archer 2 User Manual download pdf

tel: 435.753.1881

web: www.junipersys.com

1132 W. 1700 N. Logan, UT 84321

I/O module

replacement instructions

Contents of I/O Module Replacement Kit

 The Archer 2 I/O Module replacement kit

includes the following items:

 Archer 2 I/O module

 Two replacement M2X6 screws

 Screwdriver

Removing the I/O module

1. Remove the bottom bumper.

2. Using the provided screwdriver, loosen four

screws to remove the battery door.

3. Remove the battery.

4. Remove the two screws from the sides of

the module. See Figure 1.

5. Carefully pull straight back to remove the

module from the Archer 2.

Installing the new I/O module

1. Inspect new module to ensure that the

pins that go into the Archer 2 are straight

and that the rubber gasket around the

pins is in place as shown. See Figure 2.

CAUTION: if the pins are not straight, do not

attempt to straighten them or use the module.

Contact a service center for a replacement

2. Place the tabs of the new module in the

grooves of the case. See Figure 3.

P/N: 24077.02 Copyright June 2014, Juniper Systems, Inc.

Information is subject to change without notice. Juniper

Systems and Archer 2 are trademarks of Juniper Systems, Inc.

3. Align the pins with the black connector on

the main board using a slight side-to-side

rocking motion.

4. Firmly push down on board above the

pins as shown, NOT on the plastic. See

Figure 4. Push until the pins seat in the

connector and there is no gap between

the module and the Archer 2.

CAUTION: If the module does not push

in with rm pressure, STOP. Remove the

module and re-inspect the pins to ensure

they are not damaged.

5. Insert two provided M2X6 screws into the

marked holes.

6. Tighten screws with the provided

screwdriver. Ensure they are snug, but

do not force them.

7. Replace the battery door.

8. Replace the bumper.

9. For additional instructions, visit http://

www.junipersys.com/Juniper-Systems-

Rugged-Handheld-Computers/

products/Archer-2/Videos.

Grooves in case

Tabs on module

Figure 1

Figure 2

Figure 4

Figure 3

These instructions are used with the following kits:

24078 AR2 Communication Module Replacement Kit

24201 AR2 Docking Module Replacement Kit

24389 Measurement Specialties 12-volt Module Kit

Note: 24078 kit shown. Modules may differ in appearance

I/O module 1

Summary of Contents

Page 1 - I/O module

tel: 435.753.1881 l web: www.junipersys.com 1132 W. 1700 N. Logan, UT 84321I/O modulereplacement instructionsContents of I/O Module Replacement

Comments to this Manuals

No comments

Juniper-systems I/O module Archer 2 User Manual

Browse online or download User Manual for Equipment Juniper-systems I/O module Archer 2. Juniper Systems I/O module Archer 2 User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Equipment Juniper-systems I/O module Archer 2