Juniper-systems ltra-Rugged Field PC Extended Caps User Manual

Installation InstructionsUltra-Rugged Field PC Extended CapsOur extended caps maintain the full ruggedness of the Field PC while allowing you to use

Mounting an External DeviceOverviewThe Field PC features a convenient cable channel that hides cables attached to an external device you mount on the

2. Thread the sensor cable along the cable channel and out through the body molding. 3. With the cable in place, slide the body molding into place and

5. Make sure the seal adapter plate is properly installed. CAUTION: The seal adapter plate must be installed to seal the Field PC. If you have not

7. Slide the extended cap onto the Field PC and push the sensor cable through the incision you made so that the cable exits out of the top of the

8. Tighten the cap screws until they are rmly in place. To properly seal the cap, apply an extra ¼ to ½ turn after the screws become hard to turn.149

P/N 15147-02© Copyright 05/11. Juniper Systems, Inc. All rights reserved. Information subject to change without notice. Selection ChartCF & SDIO c

2Package ContentsCommunication Cap:• Foam pads in different sizesUniversal and Optical Caps:• Foam pads in different sizes• Seal adapter plate and scr

3 Table of ContentsCommunication Cap ... 4Universal and Optical Caps ...

Communication CapThis section explains how to install the Communica-tion Cap. For instructions on installing the Universal and Optical caps, see the n

3. Tighten the Communication Cap screws until they are rmly in place. To properly seal the cap, apply an extra ¼ to ½ turn after the screws become ha

Universal and Optical Caps 1. Use a #1 Phillips screwdriver to loosen the captured top screws on the Field PC. Remove the standard cap.2. This secti

3. If you are inserting an SD or CF memory card, make it easier to remove by rst placing a card pull tab onto the card. 4. There are two types of CF

¼ inch (6 mm) gap7. The kit includes large- and medium-sized foam pieces. In-sert foam pieces inside the top of the cap to keep the device in place. S

8. Tighten the cap screws until they are rmly in place. If you inserted foam into the cap in step 6, rst press down on the cap so the screws engage